Ways To Level a Garage Floor

Ways to Level Your Garage Floor 

Leveling process you can do when your garage floor is cracked and uneven. 

Grind out the high spots

If the state of your concrete floor isn’t too terrible, we can level your garage floor using our sanding approach. The concrete is sanded using a diamond sander in this process. This technique might sometimes be sufficient to level your garage floor. However, heavy machine duty and further operations may be required at times for leveling. 


 It’s possible that the most suitable garage floor leveling solution for your situation is to use a self-leveling coating. This technique requires scarifying your substrate or concrete slab. A primer is then applied to the concrete floor to allow for better adhesion of the self-leveling coating. Through gravity, this coating makes it possible to level your garage floor. Slope corrections may be necessary in certain cases. This can only be done in a small area of the garage because the garage carries a lot of weight. And if done in a large area, it will definitely cause a lot of cracks. 

Slurry or mixture Based slab jacking 

Slab Jacking One method for correcting the tilt of an entire concrete slab floor is slab jacking. You can’t do it yourself, and it’s costly. However, it is still less expensive than tearing down and rebuilding your garage. Use your existing concrete slab, requiring only minor touch-ups if attempts to lift the slab are successful. A matrix of gaps, each around 1-2 inches in diameter, is bored into the concrete, also known as concrete elevating. The holes are then filled with a mixture of sand, gravel, ash, and water. The slurry is not injected at random by technicians. They must ensure that the slab is supported in all regions by testing and intuition. If one location receives too much pressure, the slab may break as a result of the force. If there isn’t enough slurry in one region, it will be left unsupported and will ultimately crack and shatter. The mud takes about a day to harden to its final strength of about 2,400pounds per square inch However, professionals may control this by adding varying quantities of lime or sand.. Due to the reduced cost of the source product and the fact that it is a well-established process with several companies providing the service, plate lifting using slurry will be significantly cheaper than polyurethane-based lifting. 

Polyurethane Foam Slab Jacking

Slurry injections are comparable to foam injections, however, foam injections are regarded as more successful because technicians can better estimate polyurethane foam expansion. Slurry injections necessitate larger injection holes and more of them, as well as more product pumped beneath the slab. Foam slab jacking necessitates holes somewhat larger than 1/2 inch in diameter. The foam is injected once the hose is put into the hole, and a set length of time passes while the foam grows to its maximum size. After the injections, the holes are sealed with patching concrete. In addition, the foam result is significantly lighter than mud. 100-150 pounds of slurry is equal to 3-4 pounds of polyurethane. One rationale for using a lighter base product is to prevent adding additional weight to the soil. As a result, it is frequently employed in situations where weight is a concern, such as near bridges. Because of the expense of the source product, poly-based slab jacking will cost around four times as much as slurry-based slab jacking.

How thick should a garage floor be?

Due to the large weight that a garage always carries, ranging from cars to trucks and heavy machines, the garage needs to be four inches thick. Best garage floor leveling compound.

Leave a Reply

Your email address will not be published. Required fields are marked *